全民彩票In the production of wide mouth glass bottles, there are many manual machines (there are also pedal type manual turning over small mouth bottle process), and two production processes of assembly line. The process is different, and the price is also different. Many customers do not understand and do not understand. The specific differences are as follows:
全民彩票1. Manual machine wide mouth glass bottle, due to manual operation, will make different product effects and quality due to different operators, especially the obvious place is at the bottom of wide mouth bottle, the uniformity will vary from person to person, but the operation time of a single variety will be improved, while the assembly line is different, and the machine parameters and bottle drop number controlled by computer numerical control program will be very uniform and accurate, The product finish, evenness and crescent line at the bottom of the bottle are very clear and beautiful. It is suitable for large-scale assembly line container filling, which can improve production capacity and output efficiency.
2. During the operation of the production process of the manual machine, the mould of the wide mouth bottle will be put off or not in place. It is not true, and the uniformity of the wide mouth bottle will be greatly different. However, the manual operation will be more flexible than the assembly line due to the individual bottle type, so as to achieve the product effect that the assembly line cannot produce.
3. The manual machine mold is mostly opened by handle. The shape cooling and closing line of bottle will be affected by the time and length of blowing air and opening and closing mold. The assembly line is different. The mold vent hole and opening and closing time are very accurate, which has little impact on the product shape, and the product mold closing line will be very small.
4. The manual machine production process does not have high requirements on the production site and production change time. It can meet the needs of small quantity of customers flexibly. The mold production time is short and the cost input is small. It is also one of the reasons why the manual machine process has been popular with glass bottle manufacturers. The assembly line will have certain requirements on the production site and product quantity.
5. Now many glass bottle manufacturers will install two processes, manual machine and assembly line, on the same kiln, so as to achieve complementary production capacity, maximize production efficiency and meet the needs of different customers.